Forum

Diffs and Breathers

Misc. discussion topics, but keep it NZFWDA related please

Diffs and Breathers

Post by Benjamin Thomas Claude Satterthwaite on Wed Oct 25, 2017 12:19 pm

Gadday guys I'm new to the page and have a couple questions about diffs and diff breathers that I was hoping someone could help me out with. I have a 1993 SWB landcruiser lx, it has both rear and front diff lockers that both have breathers running into the engine bay. However I have recently done some crossings and water seams to get into my diffs (even tho the water hasn't gone above my breathers) could this be due to water being sucked in though pinion Seals due to not letting the diffs cool for a couple minutes before crossing. The breathers are also reasonably old so could they need replacing due to being blocked ? Was wondering if anyone has some tips or ideas about why I might still be getting water in my diffs, any help would be appreciated- cheers Ben
Benjamin Thomas Claude Satterthwaite
 
Posts: 3
Joined: Wed Oct 25, 2017 11:43 am

Re: Diffs and Breathers

Post by Alan Geeves on Wed Oct 25, 2017 5:48 pm

They could be blocked or not big enough. Also your seals might be less than perfect. Also what were you doing before the water? If you have been working things hard they will be hot and the air inside the diff will contract rapidly when cooled by water If the breather cant supply enough air it has to come from somewhere. Your seals are designed to keep oil in not necessarily water out
I hear the train a comin Its rollin down the line. I only hope the rails and sleepers are all installed in time
Alan Geeves
 
Posts: 60
Joined: Sun May 30, 2010 6:16 pm

Re: Diffs and Breathers

Post by Benjamin Thomas Claude Satterthwaite on Wed Oct 25, 2017 9:34 pm

Thankyou for the information, I was driving around before crossing but not any faster than 50km/h. My rear diff does have a very slow leak in it from witch a little oil does ooze from, could this be having an effect on water getting inside ?
Cheers Ben
Benjamin Thomas Claude Satterthwaite
 
Posts: 3
Joined: Wed Oct 25, 2017 11:43 am

Re: Diffs and Breathers

Post by Flynn Leckie on Thu Oct 26, 2017 11:41 am

Hi there Ben, i have a workshop in the Canterbury area and i would be more than happy to take a look at it.
Flynn Leckie
 
Posts: 1
Joined: Thu Oct 26, 2017 11:36 am


Return to General